Juniper MX10004 - Connect the MX10004 Router to External Devices; Connect an MX10004 Router to a Network for Out-Of-Band Management

RELATED DOCUMENTATION
General Safety Guidelines and Warnings | 239
Grounded Equipment Warning | 251
Connect the MX10004 Router to External Devices
IN THIS SECTION
Connect an MX10004 Router to a Network for Out-of-Band Management | 139
Connect an MX10004 Router to a Management Console | 140
You can manage the Juniper Networks MX10004 router using the two management ports. You can also
manage it using the console port on the Roung and Control board (RCB) for out-of-band management.
The topics in this secon describe how to connect an MX10004 router to external management devices.
Connect an MX10004 Router to a Network for Out-of-Band
Management
Ensure that you have an appropriate cable available. See "Management Port Pinouts for the MX10004
Router" on page 103 and "Connect an MX10004 Router to a Management Console" on page 140.
You can monitor and manage an MX10004 router using a dedicated management channel. Each
MX10004 RCB has two management ports: a 10/100/1000BASE-T RJ-45 port for copper connecons
and a 1-Gigabit Ethernet (GbE) small form-factor pluggable (SFP) port for ber connecons. Use the
management ports to connect the RCB to a network for out-of-band management.
NOTE: You must congure the management ports before you can successfully connect to the
MX10004 using the management ports. You cannot use the management ports to perform the
inial conguraon of the MX10004. See "Perform the Inial Conguraon for the MX10004
Router" on page 141.
139