Juniper MX10004 - JNP10 K-PWR-DC2 Power Specifications

JNP10K-PWR-DC2 Power Specicaons
Table 19 on page 52 lists the power specicaons for the high-voltage direct current (HVDC) power
supply used in MX10004 routers.
Table 19: Power Specicaons for the JNP10K-PWR-DC2 Power Supply
Item Specicaons
DC input voltage
• Minimum operang voltage: –40 VDC
• Nominal operang voltage: –48 VDC
• Operang voltage range: –40 VDC through –72 VDC
DC input current rang
• 76-A maximum at minimum operang voltage (-40 VDC) with
80-A DIP switch seng and 5500-W output load
• 64-A maximum at nominal operang voltage (–48 VDC) with
80-A DIP switch seng and 5500-W output load
• 60-A maximum at minimum operang voltage (-40 VDC) with
60-A DIP switch seng and 4400-W output load
• 50-A maximum at nominal operang voltage (-48 VDC) with
60-A DIP switch seng and 4400-W output load
Output power
• 2200 W for low-input (60-A) single feed
• 4400 W for low-input (60-A) dual feed
• 2750 W for high-input (80-A) single feed
• 5500 W for high-input (80-A) dual feed
Table 20 on page 53 shows the physical specicaons for a JNP10K-PWR-DC2 power supply.
52