Juniper MX10004 - JNP10 K-PWR-AC2 Power Supply Leds

JNP10K-PWR-AC2 Power Supply LEDs
The JNP10K-PWR-AC2 power supply has four LEDs on its faceplate: !, OK, 2, and 1. These LEDs display
informaon about the status of the power supply. See Figure 20 on page 42.
Figure 20: LEDs on a JNP10K-PWR-AC2 Power Supply
1—
! Fault
3—
2 INP2–Source input 2
2—
OK Power OK
4—
1 INP1–Source input 1
NOTE: Physical markings on the power supply are 1 and 2. These markings correspond to INP1
and INP2 in the show chassis power output (see Table 14 on page 42).
You can display the DIP switch sengs for input and output power using the show chassis power
command.
Table 14: Physical Markings on Chassis Versus show chassis power Command
Physical Marking on JNP10K-PWR-AC2 show chassis power Command
INP1 INP1
42