Juniper MX10004 - Page 53

Table 14: Physical Markings on Chassis Versus show chassis power Command (Connued)
Physical Marking on JNP10K-PWR-AC2 show chassis power Command
INP2 INP2
Table 15 on page 43 describes the LEDs on a JNP10K-PWR-AC2 power supply.
Table 15: JNP10K-PWR-AC2 LEDs on an MX10004
LED Color State Descripon
1 or (INP1 in CLI output)
Yellow Blinking The input voltage is present, but a fault is
detected.
Green Solid The power supply is funconing properly.
Unlit O The power supply is switched o; voltage is zero.
2 or (INP2 in CLI output)
Yellow Blinking The input voltage is present, but a fault is
detected.
Green Solid The power supply is funconing properly.
Unlit O The power supply is switched o; voltage is zero.
OK (Power OK) Green Solid The power supply is funconing properly.
Yellow Blinking The power supply output has detected a fault.
! (Fault) Red Solid The power supply has failed and must be
replaced.
Unlit O The power supply is funconing normally.
43