Juniper MX10004 - MX10004 Power System Maintenance

MX10004 Power System Maintenance
SUMMARY
Maintaining a Juniper Networks MX10004 router
includes replacing power supplies. Replacing includes
removing a failed power supply and installing a
funconal power supply.
IN THIS SECTION
Install a JNP10K-PWR-AC2 Power
Supply | 148
Remove a JNP10K-PWR-AC2 Power
Supply | 151
Install a JNP10K-PWR-DC2 Power
Supply | 154
Remove a JNP10K-PWR-DC2 Power
Supply | 161
The MX10004 routers support AC, DC, high-voltage alternang current (HVAC), and high-voltage direct
current (HVDC) power supplies. All power supply models are hot-insertable and hot-removeable eld-
replaceable units (FRUs). You can install up to three power supplies in the rear of the chassis in the slots
provided along the le side.
The following topics describe how to install and remove the power supplies in an MX10004.
CAUTION: Use the same type of power supply in all slots. Do not mix power supply
models in the same chassis.
NOTE: See the heat symbol
. Wear heat-resistant hand gloves while accessing the fan tray and power supply.
147