Juniper MX10004 - Page 136

8. Starng at the boom, aach the chassis to the rack by inserng eight rack mount screws through
each open ange hole and rack hole (see Figure 42 on page 126).
Figure 42: Aach the Chassis to the Rack
9. If you used a li to mount the router, move the li away from the rack.
10. Check the alignment of the router. The mounng screws on each side of the rack should line up,
and the router should be level. Tighten the screws.
11. Insert the safety restraint between the rear posts of the rack. It should rest on the top of the
chassis and align with the holes in the rack.
126