Juniper MX10004 - Page 135

CAUTION: If you are mounng more than one router, mount the rst one at the
boom of the rack. Do not aempt to mount a router manually in an upper
posion in a rack.
NOTE: The chassis has two handles that are designed for subtle posioning of the
chassis. Do not li the chassis by the handles.
b. With one person on each side and one person in the rear, hold the boom of the chassis and
carefully li it onto the mounng tray (see Figure 41 on page 125).
Figure 41: Li the MX10004 Manually
7. Carefully slide the chassis onto the mounng tray unl the chassis anges contact the rack rails.
The mounng blades ensure that the holes in the chassis anges line up with the holes in the rack
rails.
125