KAMAZ 5490 - Page 215

17
Glow plug
- Dismantle the air intake, rubber cap
protecting the glow plug, disconnect the leads,
unscrew the ignition plug and remove carbon
deposit from it.
- check the glow plug rubber cap for
mechanical damage, and in case of detection,
replace the glow plug.
Visual inspection
Special purpose
wrench, clean rags,
benzene (acetone),
screwdriver.
Every
500h
Combustion chamber
Clean up the ∅ 1.5 mm hole for air supply to the
ignition plug
Visual inspection
КО-13 wrench,
screwdriver
Every
500h
Fuel system
Check the fuel pipe for leakage; tighten up clamp
connections, if necessary.
Visual inspection screwdriver +
Fluid system
Clean up the heat exchanger
Visual inspection
КО-13 wrench,
screwdriver,
brush, t
ank for
cooling liquid
Every
500h
Check the fluid system for leakage; tighten up
clamp connections, if necessary.
Visual inspection
КО-13 wrench,
screwdriver
+
+