15
9.9 ERROR CODES, THEIR DESCRIPTION AND REMEDIAL PROCEDURE
Error code Description Remedial procedure/ customer
INIT
Function of machine recognition is
switched on.
Timing device EasyStart was switched off,
and then it was switched on again.
Wait until the machine recognition finishes, then set
the exact time and day of the week.
NO SIGNAL
The device does not respond to commands.
Check the heater fuse, replace if necessary. Contact
the service center.
Error
Heater 1 failure. Contact the service center.
Reduced voltage supply.
Charge the battery, if necessary, contact the service
center.
°C
Temperature sensor is defective. Contact the service center.
To Next Page
Loading...