Keba KeDrive D3-DU 3 A Series - Page 83

D3-DU 3xx/A, /B Operating behavior
Project engineering manual V1.09
83
© KEBA 2021
1. Level 2. Level 3. Level 4. Level Description
Restore
ParamSet
Write
Param-
Set...
Recovery is performed
The following states can be dis-
played:
● Restore ParamSet Ok:
Successfully completed.
● Restore ParamSet
Failed: An error has oc-
curred.
D<n>-4
Service
Firmware
Update
Firmware
Update
<Location>
Performing a firmware update
EoE must be enabled for this com-
mand.
Locations:
● local: on CFast card of the
control under root/appld-
isk/application/
drive/drive
● /media/usb<x>/drive:
on USB stick (x: number of the
USB port of the control)
Firmware
Update
n.a.
No (valid) firmware file was found in
the directory.
Select
Firmware
<Filename>
Firmware file selection
The following file names are valid:
● DriveFirmware.tftp-
com
● D3_DA_FW_[..].tftp-
com
Firmware
Update
Are you
sure?
Confirm execution
Firmware
Update
Execut-
ing...
Firmware update is performed
Firmware
Update
Restart-
ing...
Restarting the device after a
firmware update
The following states can be dis-
played:
● Firmware Update Ok:
Successfully completed.
● Firmware Update
Failed: An error has oc-
curred.
● Firmware Update
Restart Failed: A restart
error has occurred.