624 Keysight N9927-90001 User’s Guide
System Settings
Run/Hold
“File Saving Naming Options” on page 645
“System Configuration” on page 649
“Options (Licensing)” on page 649
“GNSS (GPS+) and GPS” on page 650
“Frequency Reference Source” on page 654
“Variable Voltage Source (Opt. 309)” on page 656
“Security Level” on page 657
“Date and Time, Format, and Time Zone Settings” on page 658
“LAN Settings” on page 659
“Power ON” on page 661
“FieldFox Package Installer (N995xA, N996xA, and applies to:
N991xA/2xA/3xA units with serial number prefixes ≥5607)” on
page 661
“Date and Time, Format, and Time Zone Settings” on page 658
“Service Diagnostics” on page 663
See Also:
“Install the Lithium-Ion Battery” on page 28
“FieldFox High Temperature Protection” on page 30
Run/Hold
The Run/Hold key determines whether the FieldFox sweeps continuously or
does NOT sweep, but holds the display results of the last sweep that was
performed.
Use Hold to conserve battery power or to allow you to save or analyze the
results of a specific measurement sweep.
The current sweep mode is shown on the screen as:
— Continuous
—Hold
— is displayed while a single sweep occurs.
How to perform a single sweep while in Hold
—Press Sweep 3.
— Then choose one of the following:
To Next Page
Loading...
Need help?
General
