Keysight N9927-90001 User’s Guide 417
Remote Server Mode (Requires CPU2 and SA Hardware/SA Option 233)
Connecting Using Remote Server
Figure 16-2 FieldFox Display When Remotely Connected to a PC-based Software
The graphic above shows the FieldFox successfully connected to a PC—with
an example hostname "PC123"—and to a compatible licensed PC-based
software.
Changing Frequency Converter Head Settings
If you want to change the frequency converter head settings while using the
VSA, first it is necessary to disconnect from the 89600A VSA:
1. Disconnect from the 89600A VSA software, using the VSA’s disconnect
icon ( ).
2. Change modes to another frequency converter compatible mode (e.g.,
SA/RTSA/IQA/...)
3. Change the settings on your frequency converter head.
The frequency range in the VSA should always reflect the frequency
converter head settings when you last connected.
4. Reconnect the FieldFox to the VSA using the VSA’s software ( ).
For more information, refer to “89600 VSA Software Overview (Requires CPU2
and N991xA/3x/A5x/A6xA and SA Option 233)” on page 418.
To Next Page
Loading...
Need help?
General
