Keysight N9927-90001 User’s Guide 207
SA (Spectrum Analyzer) Mode
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))
— “EMF Features” on page 207
—EMF Setup Procedure
EMF Features
EMF has the following features:
EMF Measurement Results:
— Measure and display corrected field strength in RMS average power
— Antenna control over X, Y, and Z antenna factors downloaded via USB
— Pass/Fail limit testing supported
—External PC not required
EMF uses the following data formats:
— Field Strength units:
— dBµV/m – For use with E-field signals
— dBµA/m – For use with H-field signals
— dBG – dB Gauss
— dBpT - dB Tesla
To Next Page
Loading...
Need help?
General
