Keysight N9927-90001 User’s Guide 403
On–the–Box Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option 233 on
N991xB), GPS (Option 307) and GPS Receiver (Option 307))
How to Set Up Mapping Settings
Setting up Data Logging
— Enable the Data Logging settings:
—Press Trace 6
—To set Data Logging (Indoor)
—choose:
——Record
or
——Play
or
——Save Recall Rec-Playback
(If you have previously stored data
recordings.)
——Save Log File
or
——Recall Logs
or
——User Folder Def System
(Default = Default) or
——File Type
(Default = KML) CVS or DREC
——Record Settings then choose:
——Optional: Then Meas Interval
> ON
——Then Interval Type
> choose Time or Distance.
——Then, if applicable Time Interval
enter time interval in
seconds.
Or
——Then, if applicable Distance Interval
enter distance
interval in miters.
——Then Auto Save OFF ON
(Default = ON).
——Then Back
— If recording, then:
— Pause Resume
Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue
recording.
— Stop
Immediately
Record-Play files are saved to:
——Record-Play files are save-recalled to:
"[CurrentDevice]\RecordPlayback\Maps\"
Learn more about file settings, refer to Chapter 31, “File Management.”
To Next Page
Loading...
Need help?
General
