146 Keysight N9927-90001 User’s Guide
SA (Spectrum Analyzer) Mode
In this Chapter
“Frequency Range” on page 148
“Radio Standard” on page 150
“Channel Selection” on page 151
“Reverse Swap” on page 153
“Scale and Units” on page 153
“External Gain” on page 154
“Attenuation Control” on page 154
“Preamplifier Control (Opt 235)” on page 155
“Check for Compressed Measurements” on page 156
“Field Strength Measurements” on page 156
“Using the Antenna/Cable Editor” on page 158
“Source Tracking Offset and Offset Reversal” on page 160
“Tune & Listen (AM/FM)” on page 161
“Independent Source/Tracking Generator ” on page 163
“Resolution Bandwidth (Res BW)” on page 165
“Video Bandwidth (Video BW)” on page 166
“Sweep Type” on page 166
“IF Output” on page 167
“Sweep Acquisition” on page 169
“Very Long Sweep Times” on page 170
“Zero Span Measurements” on page 170
“Triggering” on page 172
“FFT Gating (Opt 238)” on page 175
“Single / Continuous / Restart” on page 177
“Points ” on page 177
“Trace Display States (SA Mode)” on page 178
“Average Type” on page 179
“Average Count” on page 180
“Alignments” on page 180
To Next Page
Loading...
Need help?
General
