658 Keysight N9927-90001 User’s Guide
System Settings
System Configuration
Date and Time, Format, and Time Zone Settings
Set the local date and time, Date and Time format, and Time Zone that is
shown on the FieldFox screen. The Date and Time is also used to identify files
that are saved.
The Date and Time can also be set by synchronizing with GPS satellites. Learn
more in “GPS – Distance Settings” on page 643.
How to Update Date and Time using Internet
This method of setting the Date and Time does NOT have the security
restrictions of the other methods (listed below).
This method will NOT set the correct Time Zone. You must do that using the
manual method. See below.
—Press.System 7
—Then System Configuration.
—Then More
—Then Update Time using Internet
— Connect a LAN cable that is also connected to the Internet.
—Then press Update Time using Internet
. When successful, a message is
displayed indicating the amount of time correction that occurred.
— Optional: Set the following when a Proxy server is used to connect to the
internet:
— Proxy Host – Enter the name of the proxy host.
— Proxy Port – Enter the port number of the proxy host.
How to MANUALLY set Date and Time, Format, and Time Zone
Because of licensing security, the manual and GPS Sync methods to set
Date and Time are restricted as follows:
Can be set backward no more than 5 hours at a time.
Can be set forward any amount of time.
Can be set backward or forward no more than once in a day. A new day
begins at midnight.
There is no restriction for setting the Time Zone.
To change the Date and Time backward a significant amount, send an email to
ctd-soco_support@keysight.com.
BEFORE manually setting the Date and Time, be absolutely certain that the
Time Zone setting is correct.
To Next Page
Loading...
Need help?
General
