Keysight N9927-90001 User’s Guide 639
System Settings
Preferences
Save and Reset Preferences
All preference settings can be made at one time from the Quick Settings table.
All settings that can be saved as preferences (except Battery Saver and Startup
Mode) can also be made from individual softkey selections throughout the
FieldFox menu structure. However, they remain through a FieldFox shut down
ONLY when the current settings are saved as preferences.
The table above shows a list of all of these settings and where they are
discussed in this User’s Guide.
How to save current settings as Preferences
— Using softkeys, configure the settings as you would like them to remain.
—Press System 7
—Then Preferences
—Then Save Current Settings There is a beep when your settings have been
saved.
—Press Reset Preferences
to restore the factory default settings.
Global Settings (Overview)
Choose the Global Settings values (Language, Batter Saver, and Startup
Mode). See also “Quick Settings Table” on page 637.
How to select Global Settings:
—Press System 7
—Then Preferences
—Then Preferences
— Then use arrow softkeys or the knob to select Global Settings
—Then Edit
for each of the following:
— Language (see)
— Batter Save Mode (see)
——On
——Off (default)
— Startup Mode (see)
—Then Done Edit
(for each change in setting)
To Next Page
Loading...
Need help?
General
