Keysight Technologies FieldFox N9938A User Manual

Keysight N9927-90001 User’s Guide 659
System Settings
System Configuration
—Press System 7
—Then System Configuration.
—Then More
.
—Then Date and Time
.
— Press the arrows to highlight the row to be edited.
—Then press Edit
.
— Use the arrows or rotary knob to select the field to be edited.
— Use the arrows or numeric keypad to edit that field.
—Press Cancel
or Done when the edits are complete.
—Press Done
to exit the Date and Time settings. The readout in the
upper-right corner of the FieldFox screen will update accordingly.
LAN Settings
Configure the LAN settings to be used to communicate with the Data Link
Software and connect to the FieldFox for remote SCPI operation. Learn more
about Data Link at: www.keysight.com/find/fieldfoxsupport.
Table 29-1 LAN LEDs (N995xA, N996xA, and applies to: N991xA/2xA/3xA units with serial
number prefixes ≥5607)
LAN LEDs (N995xA, N996xA, and applies to: N991xA/2xA/3xA units with serial number
prefixes ≥5607) )
When FieldFox is connected to the LAN, the flashing LAN LEDs have the following
definitions:
Green: Flashing indicates packets are being transferred.

Keysight Technologies FieldFox N9938A Specifications

General

Dynamic Range	> 100 dB (typical)
Battery Life	4 hours
Tracking Generator	Yes
VSWR Measurement	Yes
Cable and Antenna Analyzer	Yes
Vector Network Analyzer (VNA)	Yes
Power Meter	Yes
GPS Receiver	Yes
Resolution Bandwidth (RBW)	1 Hz to 1 MHz
Measurement Functions	Return Loss, Cable Loss, Distance-to-Fault, Smith Chart, S-parameters, Spectrum Analysis
Operating Temperature	-10°C to +50 °C
Display	8.4-inch color touchscreen LCD
Storage Temperature	-40 to +70 °C