Keysight E6680A - Page 975

8 Trigger
8.1 Trigger
except ACP
In WLAN, all measurements
In Phase Noise, all measurements except Log Plot and Spot Frequency
"ADC Trigger" on page
987
ADC
All Modes and measurements supporting Video or Level, except Spectrum
Analyzer mode
Only supported in certain model’s IF Paths
"Line" on page 988
LINE
All Modes except EMI, Avionics and Analog Demod
In Spectrum Analyzer, all measurements except List Sweep
In WLAN and GSM/EDGE, all measurements except Power vs. Time
In LTE and 5G NR, all measurements except Transmit On/Off Power
In Short Range Comms, all measurements except Modulation Analysis
In MSR, all measurements
Level [Mode: RTSA,
PULSEX]
LEVel
RTSA and Pulse Modes only
FMT [Mode: RTSA,
PULSEX]
FMT
RTSA and Pulse Modes only
"External 1" on page 988
EXTernal1
All Modes and measurements
"External 2" on page 989
EXTernal2
All Modes and measurements
"External 3" on page 990
EXTernal3
See "External 3 Support" on page 976
"RF Burst" on page 991
RFBurst
All Modes except EMI
In Spectrum Analyzer, all measurements except List Sweep
"Periodic" on page 992
FRAMe
All Modes except EMI
In Spectrum Analyzer, all measurements except List Sweep
TV [Mode: SA]
TV
Spectrum Analyzer Mode only, and only in the Swept SA measurement
975 IQ Analyzer Mode User's &Programmer's Reference