8 Trigger
8.1 Trigger
I/Q Triggers
"I/Q Mag" on page 994
IQMag
All Modes except EMI, Avionics, RTSA, Analog Demod and Pulse
In Spectrum Analyzer, only in Power Stat CCDF and Burst Power
In WCDMA, only in Power Stat CCDF and IQ Waveform
In GSM/EDGE, only in EVM, GMSK Phase & Freq Error, Transmit Power
and IQ Waveform
In Phase Noise, only in IQ Waveform
In Bluetooth, only in Transmit Analysis
In LTE, only in Power Stat CCDF, Modulation Analysis, Conformance
EVM, and IQ Waveform
In WLAN, only in Power Stat CCDF, Modulation Analysis, Spectral
Flatness, and IQ Waveform
In Short Range Comms, only in Power Stat CCDF and Modulation
Analysis
In VMA, only in Power Stat CCDF, Digital Demod and IQ Waveform
In CQM, only in Group Delay, Power Stat CCDF, and IQ Waveform
"Input I" on page 994
IINPut
"Input Q" on page 995
QINPut
"I (Demodulated)" on page
995
IDEMod
"Q (Demodulated)" on
page 996
QDEMod
"Aux I/Q Mag" on page
996
AIQMag
"PXI" on page 997
PXI
All Modes and measurements (only found in modular analyzers)
"Internal" on page 997
INTernal
All Modes and measurements (only found in modular analyzers)
"Audio External" on page
991
AEXTernal
Via the TRIG IN connector on the M9260A Audio Analyzer module
"Prot Channel Detection"
on page 998
PRTChandet
Base Station Emulation; valid UL signal detected
(PUSCH/PUCCH/PRACH/SRS)
"Prot Frame Aligned" on
page 998
PRTFrame
Base Station Emulation; periodic technology format radio frame with
data frame aligned to the BSE timing
"Prot Event" on page 999
PRTEvent
Base Station Emulation events
External 3 Support
Trigger Source External 3 is available only in certain Modes and measurements, as
follows:
5GNR
Transmit On|Off, Modulation Analysis, Power Stat CCDF, and IQ Waveform measurements only
ADEMOD
Not supported
AVIONICS
Not supported
BT
Not supported
CQM
Group Delay, Power Stat CCDF, and IQ Waveform measurements only
EMI
Not supported
GSMEDGE
IQ Waveform and Transmit Power measurements only
LTEAFDD,
Power Stat CCDF, IQ Waveform, and Transmit On|Off measurements only
IQ Analyzer Mode User's &Programmer's Reference 976
To Next Page
Loading...
