In terms of connectors, please note the following:
◆
When connectors are connected. please make sure there is no foreign body such as
trash or mental slices.
◆
When connectors are connected into servo motors, please connect to one side of servo
motor's main circuit cable and make sure ground cable of main cable connecting stably. If
operators first connect one side of encoder cable, then, encoder may have some faults
because of voltage difference between PEs.
◆
During the process of wiring, please make sure pin arrangement is correct.
◆
Connector is made of resin. Please do not add pressure to avoid damage of
connectors.
◆
When handling operations is done (cables are connected), please hold main body of
servo motors. If operators just hold cable to handle, it may cause connectors damage or
make cable cut off.
◆
If operators use bend cable, please do not add pressure to connectors during the
processof wiring. If pressure is added to connectors, it will cause connector damage.
To Next Page
Loading...
