Kinco FD5 Series - 5.4 Read;write controller configuration

Kinco FD5 系列伺服驱动器使用手册
第五章 KincoServo 上位机使用指南
62
Figure 5-5 Software version
5.4 Read/write controller configuration
This function can be used to read / write multiple parameters simultaneously for large production lots,
in order to avoid setting the controller parameters one by one.
5.4.1 Read setting from controller
Click Tools->R/W Controller Configuration->Read Settings from Controller or click the
button. The following window appears：
Figure 5-6 Transfer setting
➢ Click Open List to select a parameter list file (.cdo). The parameter appears in the window.
Click Read Settings from Controller to get the Drive Value and Result , and then click Save
to File to save the setting as a .cdi file
Attention
Do not switch off the power or disconnect the RS232 cable during firmware loading.
If the download process is interrupted, first reset controller power. Then select the
firmware file and click the Download button, and finally start RS232 communication.