Kinco FD5 Series - Write Setting to Controller

Kinco FD5 系列伺服驱动器使用手册
第五章 KincoServo 上位机使用指南
63
5.4.2 Write setting to controller
Click Tools->R/W Controller Configuration->Write Settings to Controller or click the button.
The following window appear button, the following window appears
Figure 5-7 Transfer settings
Click Open File to select a parameter settings file (.cdi). The parameter settings appear in the window.
The .cdi file contains information including object address, object value and readout result. If readout
result is “False”, “Invalid” will appear immediately in red ion the Result fied.
Click Write to Controller to get the Check Value and Result. The “False” Result means the value has
not been written successfully, probably because the object doesn’t exist in the controller. Click Save in
EEPROM and Reboot to activate all parameters.
Attention
Before writing the settings to the drive, unenable the drive, if the drive is enabled,
some objects cannot be successfully written.
Attention
⚫ The .cdo file defines which objects will be read out, but if the object doesn’t
exist in the controller, the result will be “False”(displayed in red).