Kinco FD5 Series - Full Closed Loop Mode

Kinco FD5 系列伺服驱动器使用手册
第六章 工作模式介绍
100
Figure 6-6 Master slave wiring
6.6 Full closed loop mode
The servo drive is connected to the encoder/grating ruler feedback signal at the mechanical end for
more accurate closed-loop control, which avoids positioning errors due to the mechanical system.
Grating ruler signal
Motor
Motor encoder signal
Machine
Figure 6-7 Full Closed Loop Application Case
Attention
Forward rotation means positive position counting, the default is CCW direction,
you can set the speed position direction control (607E.00) = 1, change the rotation
direction of the motor shaft