Kinco FD5 Series - Chapter 4 Controller setup with LED panel; 4.1 Panel operation

Kinco FD5 系列伺服驱动器使用手册
第四章 数字面板操作
43
Chapter 4 Controller setup with LED panel
4.1 Panel operation
After the servo system is installed and wired correctly according to the specifications and
precautions, the servo drive can be set for specific application scenarios.
Table 4-1 Panel operation instruction
MODE
SET
Num
Point
    
BUS
Key
Number/dot
/button
Function
Dot ①
None
Dot②
Used to indicate whether the data is positive or negative. Dot2 on refers negative
and off refers positive.
Dot③
When setting parameters, it is used to distinguish the current object group from
the address data in the object group；
When displaying the internal 32-bit data in real time, it is used to display the
upper 16 bits of the current 32-bit data;
Indicates that the earliest error information in the error history is being displayed
when the error history record in F007 appears at the display
Dot④
When displaying and adjusting parameters in real time, it is used to indicate the
data display format: HEX data when dot 4 is on and DEC data when dot 4 is off
Dot 4 indicates that the latest error information in the error history is being
displayed when the error history record in F007 appears at the display.
Dot⑤
Dot 5 on indicates that the data modification is confirmed successful
Dot 5 on indicates that the current displayed data is internal data
Dot 5 blinking means the power section of the drive is working
MODE
Switch function menu；
When setting parameters, press briefly to switch the setting bit, press and hold to
return to the last menu.
SET
Enter menu；
Check the values of the parameters；
Confirm the setting to access the next step；
When the internal 32 bit data appears at the display, press and hold to switch
high/low 16 bit.
▲
Press briefly increase the value slowly, press and hold increase the value rapidly；
Switch data item。