Technical requirements
In order to use the product correctly and safely, the following requirements should be always
observed：
⚫
Operation of the product in accordance with the relevant safety regulations is permitted only if the
connection and environmental conditions specified in the product technical data and the technical
requirements of all other connected components comply with the product specifications.
⚫
Please follow the instructions and read warnings in this document carefully.
Operator requirements
⚫
This product may only be operated by an electrical engineer familiar with the following regulations:
—Installation and operation of electrical control systems
—Applicable regulations for safe operation of engineering systems
—Applicable regulations for accident prevention and occupational safety
—User manual for the product
2.2 Servo motor installation
2.2.1 Installation requirements
Danger!
⚫
Please install it indoor of no rain and direct sunlig
⚫
Please do not use this product in the corrosive environment (Hydrogen sulfide,
Sulfurous acid, Chlorine, Ammonia, Sulfur, Chlorinated gas, Acid, Alkaline, Salt,
etc), flammable gas, combustible and etc.
⚫
Occasion (without Grinding fluid, Oil mist, Iron powder, cutting and etc.)
⚫
Occasion (good ventilation, no Moisture, oil and water, no heat source such as
stove.)
⚫
Occasion which is easy to be checked and cleaned.
⚫
Occasion without vibration.
⚫
Please do not use motor in the closed environment.
⚫
For installation spacing, please follow the requirements of this manual. Using
life of motors depend on working environment.
⚫
Please use screws with washers when installing the motor on the flange,
otherwise the paint on the surface of the motor may be scratched off.
To Next Page
Loading...
