Kinco FD5 Series - 1.3 Servo drive specifications

Kinco FD5 AC series servo driver manual
Chapter 1 Servo system model and
configuration description
7
1.3 Servo drive specifications
Models
FD425-□A-
000
FD425-□F-
000
FD435-□A-
000
FD625-□A-
000
Power
supply
Power supply
1PH,200-240VAC±10%
50/60Hz±3HZ (750W 7A)
(200W 3A)
1PH,3PH,
200-
240VAC±
10%
50/60Hz±
3HZ
14.0A
3PH, 380-
415VAC±10%
50/60Hz±
3HZ
12.0A
Logic power supply
No separate logic power
supply
200-240VAC±10% 50/60Hz
±
3HZ 0.5A
Current
Max continuous
output (rms)
2A(200W)
3.1A(400W)
3.9A(750W)
5A
10A
7A
Peak current
7Ap(200W)
14Ap(400W)
18Ap(750W)
18Ap
27.5Ap
25Ap
Feedback signal
Photoelectric single-turn encoder
Single-turn communication magnetoelectric encoder;
Photoelectric multi-turn communication absolute
encoder;
Dynamic braking
FD425 Drive has no built-in braking resistor，FD435
built-in 100Ω，20W limited power； FD625 built-in
300Ω，20W limited power；
If the actual power exceeds the limit power, an external
braking resistor is required (depending on the
operating conditions, mainly used in the occasions of
quick start and stop)
Dynamic braking voltage
absorption point
DC380V±5V
DC380V±5V
DC380V±5V
DC680V±5V
Overvoltage alarm
DC400V±5V
DC400V±5V
DC400V±5V
DC700V±5V
Undervoltage alarm
DC200V±5V
DC200V±5V
DC200V±5V
DC400V±5V
Cooling method
Passive
cooling
Air cooling
Weight（KG）
0.881
1.5