Section 1 Basic Printer Functions 1-49
3. 2. 6 User Mode 5: Cold Sleep Setting Mode
Please Set the Touchscreen - “?”
Always keep this mode “off”. (Do not change this setting.)
It is possible to select whether the Cold Sleep function works or not on the User Interface (UI).
The purpose of Cold Sleep Mode is to reduce power consumption by shutting off the
supply of power to the heater unit. It saves more power than Warm Sleep Mode. The
temperature of the heater unit is about 140 degrees Centigrade (284 degrees Fahrenheit)
when the KIP 5000 is ready. But if they system is not in use for an extended period, it is
best to reduce power consumption by stoping the supply of energy to the heater unit
completely.
The Cold Sleep Mode will automatically be cancelled when a print or copy job is sent.
However, it takes a few moments for the system to recover from Cold Sleep Mode because
it must raise the temperature back up to about 140 degrees Centigrade (284 degrees
Fahrenheit) (Print will not begin until the KIP 5000 is ready.)
Reference
To Next Page
Loading...
