Section 1 Basic Printer Functions 1-51
3. 2. 8 User Mode 7: Warm Sleep Setting Mode
Please Set the Touchscreen - “?”
Keep this mode always “Off”. (Do not change this setting.)
It is possible to change the timer for the Warm Sleep function on the User Interface (UI).
The purpose of Warm Sleep Mode is to reduce power consumption by reducing the
temperature of heater. The temperature of the heater unit is about 140 degrees
Centigrade (284 degrees Fahrenheit) when the KIP 5000 is ready. But if the system is not
in use for an extended period, it is advised to reduce power consumption by reducing the
temperature of the heater (Temperature is kept at about 120 degrees Centigrade (248
degrees Fahrenheit).
The Warm Sleep Mode will be automatically cancelled when a print or copy job is sent.
However, it takes a few moments for the system to recover from the Warm Sleep Mode
because it must raise the temperature back up to about 140 degrees Centigrade (284
degrees Fahrenheit) (Print does not start until the KIP 5000 gets ready).
Reference
To Next Page
Loading...
