2G0947 - 31JAN08 5-7
Diagnostics
Manual Mode • Attention LED on
• Status code: 21002 (upper),
23002 (lower)
• Button/LED on
• Cal Button/LED off
• Supply info area displays film
type, size, and count
The film in this FILM SUPPLY does
not meet AIQC standards. However,
the user has selected “Manual
Mode”, so it will be used as if it is
“Ready”.
No FILM
TRAY
• Unlock Button/LED on
• Cal Button/LED off
• Supply info area displays icon
for this state
Invalid FILM
TRAY
There is a FILM TRAY in the FILM
SUPPLY but it does not contain a
LINER/RF TAG.
Ready • Unlock Button/LED on
• Cal Button/LED off
• Supply info area displays film
type, size, and count
normal tray info The FILM SUPPLY is ready for use.
Requires
Calibration
• Attention LED on
• Status code: 21001 (upper),
23001 (lower)
• Unlock button LED on
• Cal button LED off
• Supply info area displays film
type, size, and count
Requires
Calibration
The FILM TRAY must be calibrated
before the IMAGER can print from
it.
Supply Open • Ready LED off
• Unlock Button/LED off
• Cal Button/LED off
• Supply info area blank
No FILM TRAY There is no FILM TRAY in the
FILM SUPPLY.
Unlock Pending • Ready LED off (or blinking if
active print)
• Cal Button/LED off (or
blinking if active calibration)
• Unlock Button/LED blinking
• If the FILM TRAY requires a
cover, the status code is:
Status code: 21002 (upper),
23002 (lower)
Unlock
Requested
An “Unlock” has been requested but
has not started because of one of the
following:
• films are still moving through the
IMAGER
• the FILM TRAY contains film
but has not been covered with a
FILM SAVER
Once the conditions for unlock are
met, the supply state will change to
“No FILM TRAY”.
Table 5-3: Film Supply Status Messages (Cont’d)
Film Supply
State
Local Panel Display
Web Portal
Display
Description
To Next Page
Loading...
