Kodak Dryview 5800 - Page 154

5-6 2G0947 - 31JAN08
Diagnostics
Film Supply Status Messages
The following table describes how the LOCAL PANEL and Web Portal indicate
film supply status to the user.
Warming • Ready LED off
• Warming LED on
• Number of minutes
until warm shown
Warming=xx WARNING /
PROC INIT
The PROCESSOR is
warming up and will not be
ready to print for xx
minutes.
Table 5-2: MCS Printer Status Messages (Cont’d)
Printer
Status
Local Panel Display
Web Portal
Display
DICOM Status Description
Table 5-3: Film Supply Status Messages
Film Supply
State
Local Panel Display
Web Portal
Display
Description
Calibrating • Attention LED on
• Status code: 21001 (upper),
23001 (lower)
• Unlock Button/LED on
• Cal Button/LED off
• Supply info area displays film
type, size, and count
Calibrating A calibration is in progress for this
FILM TRAY.
Failed • Attention LED on
• Status code: 21000 (upper),
23000 (lower)
• Unlock Button/LED on
• Cal Button/LED flashing
• Supply info area displays icon
for this state
Failed An error has occurred that affects
normal operation. This FILM
SUPPLY is currently not usable and
requires user intervention.
Film Covered • Attention LED on
• Status code: 21003 (upper),
23003 (lower)
Film is Covered The FILM BAG or FILM SAVER is
still on and must be removed before
the FILM TRAY can be used.
FILM TRAY
Empty
• Unlock Button/LED on
• Cal Button/LED off
• Supply info area displays film
type, size, and count
Empty and/or
sheet count of 0
There is a FILM TRAY in the FILM
SUPPLY; it contains a liner/RF tag
and the sheet count is 0.