EasyManua.ls Logo

Kodak Dryview 5800 - Page 263

Kodak Dryview 5800
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2G0947 - 31JAN08 5-115
Diagnostics
LED6* LIFT_HOME LOWER - When lit, lower FILM SUPPLY PICKUP BAR is at home (up).
LED7* FILM_SAVER UPPER - When lit, upper FILM SAVER is not present.
LED8* FILM_SAVER LOWER - When lit, lower FILM SAVER is not present.
LED9, LED10 FILM_OUT UPPER, FILM_OUT LOWER - not used, never lit.
LED11* FILM_CONTACT UPPER - When lit, the upper PICKUP is not touching film in the upper
FILM SUPPLY.
LED12* FILM_CONTACT LOWER - When lit, the lower PICKUP is not touching film in the
lower FILM SUPPLY.
LED13 LASER_ILOCK - When lit, this LED indicates LASER power is enabled. It does not mean
the LASER is energized. LASER power is enabled only when:
The 3 INTERLOCK SWITCHES are closed and,
The SERVICE SWITCH is in the Normal position.
LED14* FILM_SEP UPPER - When lit, there is no film separation (the SUCTION CUPS are not
lifting a sheet of film) from the upper FILM SUPPLY.
LED15* FILM_SEP LOWER - When lit, there is no film separation (the SUCTION CUPS are not
lifting a sheet of film) from the lower FILM SUPPLY.
LED16 DOOR_ILOCK - When lit, the 24 V motor drive voltage (Hazard 24 V) is enabled. This
voltage is enabled when: .
The 3 INTERLOCK SWITCHES are closed or,
The SERVICE SWITCH is in the Service position.
LED17, LED18 TRAY_LOCK UPPER, TRAY_LOCK LOWER - not used, never lit.
LED19* FILM_PATH2 - not used, always lit.
LED20* NIPOC_LIMIT, UPPER - Indicates that the NIP ROLLER is moving from open to closed
or from closed to open.
LED21 NIPOC_LIMIT, LOWER - not used, never lit.
LED22 FILM_PATH3 - not used, never lit.
LED23* CASS_IN UPPER - When lit, there is no FILM TRAY in the upper FILM SUPPLY.
LED24* CASS_IN LOWER - When lit, there is no FILM TRAY in the lower FILM SUPPLY.
LED25 FILM_PATH4 - not used, never lit.
LED26, LED27 BAG UPPER, BAG LOWER - not used, never lit.
HAZARD +24V Test Point for Hazard 24 volts (MOTOR supply voltage). This voltage is enabled when:
The 3 INTERLOCK SWITCHES are closed or,
The SERVICE SWITCH is in the Service position.
Table 5-7: FPM LEDs and Test Points (Cont’d)
Item Description

Table of Contents

Other manuals for Kodak Dryview 5800

Related product manuals