2-24 2G0947 - 31JAN08
Installation Instructions
b. If the SCU does not indicate a Transfer Function Table (TFT) set, use
TFTShop to select the correct TFT SET for this type of SCU. For
additional help when selecting the correct TFT SET, see the
following documents:
• Tables Specification for TFT Sets, 8F5224
• MetalutsB
TFTShop and the 2 documents above are located on the intranet at:
http://know.us.kodak.com/audience_fe001/stage/global/en/Health-Me
dical/Digital_Output/index.shtml#Tools.
c. Check the quality of an image sent down from the SCU.
d. If necessary, change the parameters.
7. Click [Modify].
8. To change a parameter, select the new parameter from the drop-down list.
9. Select the "Film and Image Options" tab.
10. Select or type the parameters.
Note:
• The value selected will be the default for this SCU.
• The field to the right of the parameter value is an indication of whether
the parameter value sent from the SCU will be "overridden". If you select
"Always Apply", the parameter on the screen will "override" the
parameter the SCU sends. If you select NO, the SCU parameter will
apply. Normally, you should select NO to allow the SCU to "override"
the default selected.
11. Select the "Other Options" tab.
To Next Page
Loading...
