2G0947 - 31JAN08 2-25
Installation Instructions
12. Select the parameters.
Note:
• The value selected will be the default for this SCU.
• The field to the right of the parameter value is an indication of whether
the parameter value sent from the SCU will be "overridden". If you select
"Always Apply", the parameter on the screen will "override" the
parameter the SCU sends. If you select NO, the SCU parameter will
apply. Normally, you should select NO to allow the SCU to "override"
the default selected.
13. After setting the parameters for this SCU, do the same procedures for
each SCU identified in the SCU connection window.
14. Click [Save].
15. After the configuration of all SCUs is completed, continue with “Editing
the Service History Log”.
To Next Page
Loading...
