Korg Karma - 3: Key Z (Keyzone)

124
4 Set KARMA module [B] as follows.
“GE Select”: a riff of GE category Bass
“Input Channel”: 02
“Output Channel” 02
5 In “Play (Track Select),” select T01:Track01, and play the
keyboard. (KARMA function on)
The Guitar riff of KARMA module [A] will be sounded
by the Guitar type program.
6 In “Play (Track Select),” select T02:Track02, and play the
keyboard.
The Bass riff of KARMA module [B] will be sounded by
the Bass type program.
[Example 2]
With the following settings, changing “Play (Track Select)”
(the track you yourself will play) to switch programs will
not switch the KARMA module --- the same phrase will still
be played. (See the diagram “Example 2” below.)
1 Set Track 1 (MIDI Channel: ch.1) as follows.
“Program Select”: a Guitar category program
2 Set Track 2 (MIDI Channel: ch.2) as follows.
“Program Select”: a Bass category program
3 Set KARMA module [A] as follows.
“GE Select”: a riff of GE category Guitar
“Input Channel”: Tc h
“Output Channel” Tc h
4 In “Play (Track Select),” select T01:Track01, and play the
keyboard.
The Guitar riff of KARMA module [A] will be sounded
by the Guitar type program.
5 In “Play (Track Select),” select T02:Track02, and play the
keyboard.
The Guitar riff of KARMA module [A] will be sounded
by the Bass type program.
KARMA Routing Map
This shows which tracks will be sounded by each KARMA
module, according to the MIDI output channel setting of
each KARMA module and the MIDI channel of each track
(Tracks 01–16 are fixed at MIDI channels 1–16).
Trck Thru (T.Thru (KRM Off)) [Off, On]
☞ p.106 SEQ 6.1–2a: MIDI I/O “T.Thru (KRM Off)”
■ 6.1–2b: UTILITY
☞ “GM Initialize” (1.1–1b)
“Solo Selected Track,” “Set Location” (SEQ 1.1–1d)
“Copy KARMA Module” (PROG 6.1–1c), “Select by Cate-
gory” (PROG 1.1–3b)
“Init KARMA Module” (COMBI 6.1–1d)
6.1–3: Key Z (KeyZone)
Specifies the range of note data (key zone) that will control
each KARMA module.
In Song Play mode, MIDI data for each KARMA mod-
ule is transmitted and received on the “Input Channel”
and “Output Channel” (6.1–2a) specified for each mod-
ule.
☞ p.27 PROG 6.1–2a: Key Z/Thru
6.1–3a: Zone Map, KeyZone Bottom, KeyZone Top
Zone Map
Solid lines indicate the key zone settings for each of the four
KARMA modules.
☞ p.27 PROG 6.1–2a: Key Z/Thru, “Zone Map”
A/B/C/D KeyZone Bottom [C–1...G9]
A/B/C/D KeyZone Top [C–1...G9]
☞ p.27 PROG 6.1–2a: Key Z/Thru, “KeyZone Bottom,”
“KeyZone Top”
■ 6.1–3b: UTILITY
☞ “GM Initialize” (1.1–1b)
“Solo Selected Track,” “Set Location” (SEQ 1.1–1d)
“Copy KARMA Module” (PROG 6.1–1c), “Select by Cate-
gory” (PROG 1.1–3b)
“Init KARMA Module” (COMBI 6.1–1d)
6.1–3a
6.1–3b
KARMA Module [A]
In : Tch
Out : Tch
KARMA ON/OFF = ON
Track 01: GuitarIn : 01ch
Track 02: Bass
In : 02ch
Play Track = Track 01
Play Track = Track 02
01ch
02ch
Guitar Riff
Guitar Riff
01ch
02ch
Example 2