COMBI
1.1
2.12.22.33.13.23.33.44.14.24.34.46.16.26.36.47.17.27.3
49
Here you can set the Combination mode functions of the B-
mode functions of real-time CONTROLS knobs [1]–[4], and
[SW1] key, [SW2] key.
2.2–1: Ctrls (Controls)
2.2–1a: Knob B Assign
These settings assign functions (mainly various control
changes) to the “B” mode of the real-time CONTROLS
knobs [1]–[4] (
☞p.231 “Realtime Control Knobs B Assign
List”).
The functions you specify here will be controlled when you
operate the real-time CONTROLS knobs [1]–[4] in “B”
mode.
Since the real-time CONTROLS knob [1]–[4] function of the
B mode assignments made for the program assigned to each
timbre are not valid for the combination, they must be
newly set by these parameters.
Knob1–B (Knob1–B Assign) [Off...MIDI CC#95]
Knob2–B (Knob2–B Assign) [Off...MIDI CC#95]
Knob3–B (Knob3–B Assign) [Off...MIDI CC#95]
Knob4–B (Knob4–B Assign) [Off...MIDI CC#95]
2.2–1b: SW1/2 Assign
These settings assign the function of the [SW1] key and
[SW2] key (
☞p.230 “SW1, SW2 Assign List”).
Since the function assignments of the [SW1] key and [SW2]
key made for the program assigned to each timbre are not
valid for the combination, they must be newly set by these
parameters.
SW1 (SW1 Assign) [Off...AfterT Lock]
SW1 Mode [Toggle, Momentary]
SW2 (SW2 Assign) [Off...AfterT Lock]
SW2 Mode [Toggle, Momentary]
(☞PROG 2.2–1b)
■ 2.2–1c: UTILITY
☞ “Write Combination,” “Solo Selected Timbre” (1.1–1c)
This page is displayed if the separately sold EXB-MOSS
option is installed.
(
☞EXB-MOSS owner’s manual & p.269 “EXB-MOSS
option”)
3.1–1: MIDI
Here you can make MIDI settings for each timbre.
3.1–1a: Status, MIDI Channel, Bank(EX2) MSB/LSB
Status [INT, Off, EXT, EX2]
Specifies the status of MIDI and the internal tone generator
for each timbre.
INT: When you play this instrument, the internal tone gen-
erator will sound, and will also sound in respond to MIDI
messages received from an external MIDI device.
Off: The program will not sound. Nor will MIDI data be
transmitted.
EXT: Playing this instrument will not cause it to sound, but
will transmit data via MIDI to control external MIDI
devices.
EX2: “Bank (EX2) MSB” and “Bank (EX2) LSB” (3.1–1a) will
be enabled. Instead of the bank numbers for A–G(d) that can
be selected on this instrument, the bank numbers you spec-
ify here will be transmitted via MIDI. In other respects this is
the same as EXT.
COMBI 2.2: Ed–Ctrl
COMBI 2.3: Ed–MOSS
2.2–1a
2.2–1b
2.2–1c
COMBI 3.1: Ed–Param1
3.1–1a
3.1–1b
On-board controllers
KARMA
Tone
generator
MIDI IN
INT
On-board controllers
KARMA
MIDI IN
EXT, EX2
MIDI OUT