234
Dynamic MIDI Sources
The sources (Dynamic MIDI Sources) are organized into the
following groups
JS +Y #01...JS X: Controller group
Short Note...Black Note: Note group
Velocity...Vel Out Z: Velocity Group
Depending on the combination of source and destination
(Dynamic MIDI Destinations), the selected destination may
not function as you intend. Refer to the explanations of com-
bining sources and destinations in each section of “Dynamic
MIDI Destinations,” and make sure to select sources and
destinations that are appropriate for each other.
For JS+Y #01...JS X, you can specify the range of control val-
ues in “Range-Btm/Top” (6.4–3a/b/c/d). Control values
within this range will be the source.
Off
No source will be selected.
JS+Y #01
The +Y direction (away from yourself) of the joystick
(CC#01) will be the source.
For JS+Y #01...JS X, you can specify the range of control val-
ues in “Range-Btm/Top” (6.4–3a/b/c/d). Control values
within this range will be the source.
JS-Y #02
The –Y direction (toward yourself) of the joystick (CC#02)
will be the source.
Pedal #04
The assignable foot pedal (CC#04) will be the source.
The function of the assignable pedal connected to the
ASSIGNABLE PEDAL jack must be assigned as Foot Pedal
(CC#04) for the GLOBAL 6.1: Controller Foot page “Foot
Pedal Assign” parameter.
Damper #64
The damper pedal will be the source.
Prta.SW #65
The portamento switch (CC#65) will be the source.
FootSW #82
The assignable foot switch (CC#82) will be the source.
The function of the assignable foot switch connected to the
ASSIGNABLE SWITCH jack must be assigned as Foot
Switch (CC#82) for the GLOBAL 6.1: Controller Foot page
“Foot SW Assign” parameter.
MIDI CC#83
MIDI control change CC#83 will be the source.
Ribbon #16
MIDI control change CC#16. The ribbon controller of a con-
nected TRITON etc. will be the source.
K.Knob1...8
The corresponding KARMA Realtime Controls knob [1]–[8]
will be the source.
If a MIDI control change is assigned in the GLOBAL
6.1: Controller KARMA1 page, this will be controlled
by reception of the assigned MIDI control change.
K.SW1/K.SW2
The KARMA Realtime Controls switch [1] or [2] will be the
source.
If a MIDI control change is assigned in the GLOBAL
6.1: Controller KARMA1 page, this will be controlled
by reception of the assigned MIDI control change.
KARM OnOff
The KARMA Realtime Controls [ON/OFF] key will be the
source.
If a MIDI control change is assigned in the GLOBAL
6.1: Controller KARMA1 page, this will be controlled
by reception of the assigned MIDI control change.
AfterT
Aftertouch (channel aftertouch) will be the source.
JS X
The X (horizontal) direction of the joystick will be the
source.
For JS X, “Pol” (6.4–3a/bc/d) allows you to select +/– or
–/+ in addition to the usual + or – operations.
When the controller is moved all the way to the left or right,
the value will change as follows. The example shown below
is for when Te mp o is selected as the destination. (Original
tempo is =100 BPM, “Range-Btm/Top”: 000/127)
+: Far left (+/–0) → far right (maximum)
100 BPM → 200 BPM
–: Far left (+/–0) → far right (maximum negative)
100 BPM → 50 BPM
+/–: Far left (maximum negative) → center (+/–0) → far
right (maximum)
50 BPM → 100 BPM → 200 BPM
–/+: Far left (maximum) → center (+/–0) → far right
(maximum negative)
200 BPM → 100 BPM → 50 BPM
Short Note
Use “Range-Btm/Top” (6.4–3a/b/c/d) to specify the range
of note numbers. Only notes within the specified range with
a duration of less than 45 ms between note-on and note-off
will be the source.
000: C-1...012: C0...024: C1...036: C2...
045: C3...060: C4...072: C5...084: C6...
096: C7...108: C8...120: C9...127: G9
Note
Use “Range-Btm/Top” (6.4–3a/b/c/d) to specify the range
of note numbers. Notes within the specified range will be
the source. (☞Short Note)
Dynamic MIDI Sources & Desti-
nations
To Next Page
Loading...
