133
1.12.13.14.15.16.1
GLOBAL
5. Global mode
In Global mode you can make settings that affect the entire
instrument, such as master tuning, MIDI, and memory pro-
tect. You can also edit user scales, drum kit setups, etc.
If you want the settings you make in Global mode to be
backed up when the power is turned off, you must
write them into memory. To write your settings, use the
Utility “Write Global Setting” or “Write Drum Kits. ”By
pressing the [REC/WRITE] key, you can access
“Update Global Setting,” “Update Drum Kits” These
commands will simultaneously write the edited con-
tent.
For details on selecting pages and parameters, refer to Pro-
gram mode “PROGRAM PAGE MENU” p.1.
1.1–1: Basic
1.1–1a: Basic
Master Tune (Master Tune [Cent])
[–50cent (427.47Hz)…+50cent (452.89Hz)]
This adjusts the overall tuning of this instrument in one-cent
units (semitone = 100 cents) over a range of ±50 cents. With a
setting of 0, the frequency of A4 will be 440 Hz.
The A4 pitch given here is when Equal Temperament is
selected as the scale. If a different scale is selected, A4
may not be 440 Hz.
Key Transpose [–12…+12]
his adjusts the pitch in semitone steps over a ±1 octave
range.
This setting is applied at the location (Pre MIDI or Post
MIDI) specified by “Convert Position” (2.1–1a).
“Master Tune” can be controlled by the MIDI universal
system exclusive message Master Fine Tuning (F0, 7F,
nn, 04, 03, vv, mm, F7: nn=MIDI channel, vv/mm=
value).
“Key Transpose” can be controlled by the MIDI univer-
sal system exclusive message Master Coarse Tuning
(F0, 7F, nn, 04, 04, vv, mm, F7: nn=MIDI channel, vv/
mm=value).
These messages are received on the global MIDI chan-
nel specified by “MIDI Channel” (2.1–1a).
In Program, Combination, Sequencer, and Song Play
modes, MIDI RPN fine tuning messages can be
received to adjust the tuning of the program, the tim-
bres (in Combination mode), or the tracks (in
Sequencer/Song Play modes) relative to the Global
mode “Master Tune” setting.
In Program mode, MIDI RPN fine tune messages will
be received on the global MIDI channel that you speci-
fied for “MIDI Channel” (2.1–1a). In other modes, MIDI
RPN fine tune messages will be received on the MIDI
channel for each timbre (in Combination mode) or track
(in Sequencer/Song Play modes). (
☞“Detune,” “Trans-
pose”: COMBI 3.1–3a, 3.1–5(6)a.)
GLOBAL PAGE MENU
Sys. 1.1: System Basic settings for this instrument
(
☞p.133)
MIDI 2.1: MIDI MIDI settings for this instrument.
(
☞p.137)
U.Scl 3.1: User Scale Scale settings created by the user. You
can specify 16 types of octave scale,
and one full-range scale. (
☞p.140)
U.Cat 4.1: Category Name Edit category names for programs and
combinations. (
☞p.141)
DKit 5.1: DKit Edit drum kits. (
☞p.142)
Ctrl 6.1: Controller Control settings for pedals etc. con-
nected to the rear panel. MIDI settings
for KARMA real-time controls. (
☞p.145)
GLOBAL 1.1: System
1.1–1a
1.1–1d1.1–1b 1.1–1c
Note number transmitted
Note number
24…84
(C1…C6)
–12 0 +12
36…96
(C2…C7)
48…108
(C3…C8)
Transpose
To Next Page
Loading...
Need help?
General
