Introduction
Rear Panel Features
1-3
Rear Panel Features
All Models
•
Mix Outputs
, use these two 1/4” jacks (Left is mono) to connect either T/S or T/R/S cables.
•
Analog Outputs Bal/Unbal
, configure these 1/4” jacks (four pairs, A–D) as stereo pairs of
individual mono outputs.
•
SCSI
ports, use these two ports to connect a hard drive or other SCSI devices.
•
SCSI Termination
switch, a slide switch to select either Auto or Disable for SCSI
termination.
•
MIDI
ports, In, Thru/Out, and Out, to use with other MIDI devices to receive, pass, and
send MIDI data.
•
MIDI Select
switch, a slide switch to select the operation of the Thru/Out port.
•
Kurzweil I/O
, use these serial ports to send or receive the Kurzweil KDS format.
•
Digital I/O
, use these XLR jacks to send or receive digital information.
•
Optical Out
, use this jack to send or receive digital information from external devices with
an optical in jack.
Keyboard Models only
•
Power Entry Module
, includes the power switch, AC connector, fuse holder, and voltage
select switch.
•
LCD Contrast
, turn this potentiometer to adjust the LCD for the best visibility.
•
CC Pedals/Breath
, use these two 1/4” jacks to connect external control pedals (10k
Ω
linear
taper potentiometer, ring/tip/sleeve). Use the 3.5mm jack to connect a breath controller.
•
Switch
Pedals
, use these four 1/4” jacks to connect footswitches.
•
Inputs
, this section is covered by a plate if the sampling option is not installed.
• For units with the sampling option, use either the two Lo Z XLR or the Hi Z 1/4”
(tip/ring/sleeve) jacks for sampling from an analog source.
• Optical In, If sampling from a digital source with an optical out jack, use this input.
•
Headphones
: use this 1/4” jack to connect headphones.
Rack Models only
•
Power Entry Module
, includes the AC connector, fuse holder, and voltage select switch.
To Next Page
Loading...