1-6
Introduction
K2600R Front Panel
K2600R Front Panel
Figure 1-5 Front panel, K2600RS rack model
Rack Models only
•
Power
switch, push switch to turn the unit on and off.
•
MIDI LED
, this LED flashes when receiving data from a MIDI controller.
•
Headphone
jack, use this 1/4” jack to connect headphones.
•
Volume
potentiometer, adjusts the overall volume of the mixed audio outputs and the
headphone jack.
•
LCD Contrast
, turn this potentiometer to adjust the LCD for the best visibility.
•
Disk Drive
, use the disk drive to load, save, and copy data to a floppy disk. Use formatted
double-sided, double density (DSDD—720K or high-density (HD—1.4M) disks.
•
Inputs
, this section is covered by a plate if the sampling option is not installed.
• For units with the sampling option, use either the two Lo Z XLR or the Hi Z 1/4”
(tip/ring/sleeve) jacks for sampling from an analog source.
• Optical In, If sampling from a digital source with an optical out jack, use this input.
MIDI LED
MIDI LEDMIDI LED
Disk Drive
LCD
Contrast
Power
Volume
Headphone
Alpha wheel,
Minus (–) and
Plus (+) buttons
Exit
button
Mode
buttons
Edit
button
Optical
In
Inputs
Cursor
buttons
LCD and
Soft buttons
(below)
Alphanumeric
buttons
Chan/Bank,
Layer/Zone
buttons
Program MIDISetup Master SongEffects DiskQ Access
Mute 1 JumpMute 2 Mute 3 CompareFX Bypass MarkPrevious Pg
LinkSamp/SecZoom +Zoom - Gain - Gain +
Power
LCD
Contrast
Exit
Edit
Chan/Bank
Layer/Zone
MIDI
Optical
12 3
456
789
+ / - 0 Clear
Cancel Enter
Space0-9UPPER/lower
ABC DEF GHI
JKL MNO PQR
STU VWX YZ
Volume
Headphone
Lo Z
Left
Right
Hi Z
Left
Right
InputsData Entry
To Next Page
Loading...
Need help?
General
