10.8.5 Level Control (from a rotary encoder)
Under the "Level Control" branch of the ‘Tree Definition’ you will find all of the system's assignable rotary
controls, known as VCAs. These can be used to control any level such as the output level of a Minimixer.
The number of physical controls, and their parameters, vary depending on the system. They can be found on:
·
The Central (or Monitor) Modules defined in Frames -> Surface.
·
Some of the key panels defined in Frames -> Panels.
·
Some DALLIS IO cards, such as the 945/61 DALLIS Headphone Output card or 945/05 GPIO card.
For each control, the most important parameter is its Reference name. The other parameters vary depending
on the type of module. An example is included later.
Once named, the control can be used to control the level of another element by clicking on any yellow "Level"
parameter field and selecting the control 's Gain Out in the 'Tree Selection':
To Next Page
Loading...