LELY Vector - Connect the Mixing and Feeding Robot Manually to the Charger; Lower the Skirt to Clear the Route of Snow

5.2011.8583.0 C
Operating Instructions 5-35
6. Activate:
•
[L] to turn right
•
[R] to turn left
• [L] and [R] to go straight on
7. Push
to change the direction, if necessary.
8. Use the buttons
and to adjust the speed, a percentage of the maximum driving speed is
displayed.
9. Push
to start, hold it.
10. Release
to stop.
5.8.2 Connect the Mixing and Feeding Robot Manually to the Charger
To connect the Mixing and Feeding Robot manually to the charger use the page Work and see the
explanation of the third tab MANUAL CHARGER (see Put the Mixing and Feeding Robot In Operation on
page 5-2).
5.8.3 Lower the Skirt to Clear the Route of Snow
Do not use de-icing salt on the route, only use it when there is no other option. This may
cause corrosion and damage the Mixing and Feeding Robot. It is best to use sand.
During periods of frost and snow fall the routes of the Mixing and Feeding Robot outside the barn must
be de-iced and cleared of snow. During this period it is recommended to let the Feeding Robot drive
outside the barn with a lowered skirt. With heavy snowfall use for example a shovel to clear the route.
To lower the skirt on the routes outside the barn do the following:
1. Start the WebUI (see page 5-16).
2. Push the button
Settings.
3. Go to the pageRoutes.
4. Select a route (>).
in n o vato rs in agriculture