5.2011.8583.0 C
5-24 Operating Instructions
2. Wait until the page is found, in the top bar three options are displayed:
• Login.
• Connected devices.
• Active alarms.
3. Click on login and use the username and password you received from your Lely technician to log in.
4. Select the device at Connected devices.
5. Click on Reset alarms to reset the alarms.
5.4.5 Reset an Alarm on the Mixing and Feeding Robot and Continue Route
When an unfinished task is still present when the Mixing and Feeding Robot is put into
operation a question appears if you want to finish the task, which means if you want to
continue to do that task.
• Use Yes, if you stopped during a feed task and want the Mixing and Feeding Robot to
continue where it stopped. If it was waiting for the Feed Grabber to dump feed in the
mixing bin, the Mixing and Feeding Robot will send the task to the Feed Grabber
again. If it was driving a route action it will continue with the route action.
• Only use No, if you want all data from the feed task to be deleted and you want the
Feed Controller to send a new task to the Mixing and Feeding Robot. Keep in mind
that when a task is stopped after feed has been dispensed at the feed location, this
data is lost and is not reported to T4C.
Unexpected movement of vehicle.
Risk of personal injury.
Make sure the Mixing and Feeding Robot and the immediate vicinity is void of persons
and animals. Only operate the Mixing and Feeding Robot with the smartphone when it
is in your line of sight.
1. Connect the smartphone to the Mixing and Feeding Robot.
2. Read the alarm message, if necessary see chapter Troubleshooting to see what actions should be taken
to remove the cause of the alarm.
3. Push
to confirm the alarm message.
in n o vato rs in agriculture
To Next Page
Loading...
