5.2011.8583.0 C
5-4 Operating Instructions
5.1.3.2 Put the Feed Kitchen in the Filling Mode with the Smartphone
When for example driving on a (silage) block cutter, you can take the feed kitchen out of
operation with a smartphone without leaving the vehicle.
1. Connect the smartphone (see Connect the Smartphone to Device Software on page 5-15) to the Feed
Controller.
2. Go to the page Feed kitchen.
3. Push
The signal lights start blinking green and orange. The Feed Grabber will be parked.
4. Wait until the signal light is blinking green. It is then safe to enter and fill the feed kitchen.
5.1.3.3 Put the Feed Kitchen in the Filling Mode with the WebUI
1. Start the WebUI (see page 5-16).
2. Push the button
Kitchen.
3. Push the button Start fill mode.
The signal lights start blinking green and orange. The Feed Grabber will be parked.
4. Wait until the signal light is blinking green. It is then safe to enter and fill the feed kitchen.
5.1.4 Take the Mixing and Feeding Robot Out of Operation
You can take the Mixing and Feeding Robot out of operation with the pause button or with the
smartphone.
in n o vato rs in agriculture