LELY Vector - Examine the Reports in the Mixing and Feeding Robot Software; Empty the Mixing bin and Tare the Load Cells

5.2011.8583.0 C
Maintenance Procedures 6-19
4. Turn the screw (BT 6x65) a bit in the duo plug.
5. Use a hammer to insert the plug and screw through the metal strip. Make sure the top of the plug is
level with the concrete.
6. Use a bit T30 to tighten the metal strip with the screws (BT 6x65). Tighten only with a torque of 20 Nm,
it must still be possible to move the strip.
6.2.10 Examine the Reports in the Mixing and Feeding Robot Software
1. Connect the smart phone to the Mixing and Feeding Robot.
2. Go to the page Alarms > Report list.
3. Read the messages of the last few days. If some messages occur more often than should be expected,
try to solve the issue or contact your Lely service technician for advise. Examples are messages
concerning batteries or a silo.
6.2.11 Empty the Mixing Bin and Tare the Load cells
Because the mixing bin will never be completely empty after feeding at the end of a location it is best to
tare with the amount of feed in the mixing bin that always stays in. Do this procedure when the mixing bin
is filled too much and the measured feed weight is zero.
Preparation
1. Manually drive (see Drive the Mixing and Feeding Robot Manually on page 5-34) the Mixing and
Feeding Robot to a feed fence.
Empty the mixing bin
1. Connect the smartphone (see Connect the Smartphone to Device Software on page 5-15) to the Mixing
and Feeding Robot.
2. Open the feed door on the page Test > Testing motors > Feed door.
3. Push
to select the direction and to start or stop the motor.
4. Start the dosing roll in the correct direction on the page Test > Testing motors > Dosing roller.
5. Push
to select the correct turning direction, and to start or stop the motor.
6. Start the mixer in the correct direction on the page Test > Testing motors > Mixer.
To avoid damage to the motor or frequency regulator, do not turn the mixer motor
faster than with a frequency of 50 Hz.
7. Push
to select the correct turning direction, and to start or stop the motor.
8. Manually drive along the feed fence.
in n o vato rs in agriculture