5.2011.8583.0 C
Maintenance Procedures 6-21
2. Use a wet cloth to remove fly droppings and dirt from the glass of the laser.
Close-up
1. Put the Feed Grabber in operation (see Put the Feed Grabber In Operation on page 5-6).
Figure 65. Feed height sensor
KEY: 1. Cover - 2. Laser
6.3.2 Clean the Jaws of the Feed Grabber
Preparation
1. Connect the smartphone to the Mixing and Feeding Robot.
2. Manually drive the Mixing and Feeding Robot away from the feed loading point.
3. Push the pause button and switch off the Mixing and Feeding Robot with the key (see procedure).
4. If there are 2 Mixing and Feeding Robots, push the pause button on the second Mixing and Feeding
Robot and switch off the Mixing and Feeding Robot with the key.
Position the Feed Grabber
1. Take the Feed Grabber out of operation (see procedure).
A no go zone is an area in the feed kitchen with a wall or equipment over which the Feed
Grabber must never drive. If there is a no go zone in your feed kitchen, first drive the
feed Grabber away from the no go zone before you drive the Bridge Crane.
in n o vato rs in agriculture
To Next Page
Loading...
