5.2011.8583.0 C
5-14 Operating Instructions
5.1.7 Connect the Vector to the Power
5.1.7.1 Connect the Vector to the Power and Start Up
1. Open the power distribution box and make sure the backup battery (2) is connected with connector (1)
(see figure 40 on page 5-10).
2. Set the power supply switch (see figure 39 on page 5-9) in the position “1” on the power distribution
box.
3. Switch on the main switch near the battery on the Mixing and Feeding Robot (see Switch on the Main
Switch on the Mixing and Feeding Robot on page 5-14).
4. Switch on the Mixing and Feeding Robot with the key (see Switch on the Mixing and Feeding Robot
with the Key on page 5-14).
5. Put all devices in operation:
1. Put the Feed Grabber in Operation (see Put the Feed Grabber In Operation on page 5-6).
2. If present put the Bridge Crane in operation (see Put the Bridge Crane In Operation on page 5-7).
3. Put the Mixing and Feeding Robot in operation (see Put the Mixing and Feeding Robot In Operation
on page 5-2).
6. Put the feed kitchen in operation (see Put the Feed Kitchen in Operation on page 5-1).
5.1.7.2 Switch on the Main Switch on the Mixing and Feeding Robot
1. Rotate the skirt until the skirt piece is on the back of the Mixing and Feeding Robot.
2. Remove the bolts (1) (see figure 43 on page 5-13) and the skirt piece (2).
3. Turn the main switch (3) of the Mixing and Feeding Robot to the On position.
4. Install the skirt piece (2) with the bolts (1).
5.1.7.3 Switch on the Mixing and Feeding Robot with the Key
1. Insert the safety key (3) (see figure 41 on page 5-11) and turn it to the ON position.
2. Connect the smartphone to the Mixing and Feeding Robot.
3. Read the alarm message.
4. Push
to reset the alarm.
5. If the safety key on Mixing and Feeding Robot was turned during driving a route, the following
message appears:
Pausebutton must be pressed and released to accept alarm.
1. Push the Pause button (2).
2. Push the Pause button again to release the button.
in n o vato rs in agriculture
To Next Page
Loading...
