5.2011.8583.0 C
Maintenance Procedures 6-7
Figure 57. Clean the laser
KEY: 1. Feed height sensor
1. Use a small brush or cloth to remove all dirt and cobwebs under the laser (A) of the feed height sensor
(1) (see figure 57 on page 6-7).
2. Use a wet cloth to clean fly droppings and dirt from the glass.
Close-up
1. Install the laser cover.
2. Put the Mixing and Feeding Robot in operation (see Put the Mixing and Feeding Robot In Operation on
page 5-2).
6.2.5 Clean the Ultrasonic Sensors
Preparation
1. Take the Mixing and Feeding Robot out of operation (see Take the Mixing and Feeding Robot Out of
Operation on page 5-4).
Clean
1. Use a wet cloth to remove all dirt from the ultrasonic sensors (1) (see figure 58 on page 6-8).
in n o vato rs in agriculture
To Next Page
Loading...
