5.2011.8583.0 C
5-30 Operating Instructions
5.5.4 Enter the Feed Kitchen
All entrances of the feed kitchen are secured to prevent entrance when the Feed
Grabber is in operation. If a feed kitchen door, moving screen, the safety fence gate or
the safety fence is opened, the emergency stop is activated. If you want to enter the
feed kitchen you must put it in: filling mode.
Park the Feed Grabber and deactivate the gate/door(s)
1. Put the Feed Kitchen in the filling mode (see Put the Feed Kitchen in the Filling Mode with the Console
on page 5-3).
2. Open the door or gate of the feed kitchen.
Activate the Feed Kitchen
1. Close all doors and gates of the feed kitchen.
2. Put the feed kitchen in operation (see Put the Feed Kitchen in Operation on page 5-1).
5.5.5 Open the Safety Fence Net
1. Take the Feed Kitchen out of Operation (see procedure).
Figure 49. Open the safety net
KEY: 1. Light - 2. Winch - 3. Handle - 4. Net connector
2. Turn the winch (2) to release the tension on the
net. Turn until the net connector (4) no longer
moves.
3. Use the handles (3) to lift and unhook the net.
4. Drag the net to the side and prevent that
vehicles drive over the net.
5.5.6 Close the Safety Fence Net
1. Use the handles (3) (see figure 49 on page 5-30) to lift and hook the net connector (4) to the tensioner
pole.
2. Turn the winch (2) to put tension on the net. Turn until the light (1) is off and stop turning.
You can now put the feed kitchen in operation.
in n o vato rs in agriculture
To Next Page
Loading...
