5.2011.8583.0 C
6-20 Maintenance Procedures
9. When no more feed comes from the mixing bin:
1. Stop driving.
2. Stop the mixer on the page Test > Testing motors > Mixer.
3. Stop the dosing roll on the page Test > Testing motors > Dosing roller.
4. Close the feed door on the page Test > Testing motors > Feed door.
Push the button
to select the direction push until the feed door is closed.
Tare the loadcells
1. Go to the page Settings > Tare loadcell.
2. Make sure the mixing bin is not moving.
3. Push the button
TAR.
Close-up
1. Manually drive and connect the Mixing and Feeding Robot to the charger (see Connect the Mixing and
Feeding Robot Manually to the Charger on page 5-35).
6.3 Feed Grabber
6.3.1 Clean the Feed Height Sensor
Laser light.
Risk of getting blind.
Do not stare into the beam.
Use the Vector stepladder to do this procedure.
Preparation
1. Take the Feed Grabber out of operation (see Put the Feed Grabber In Operation on page 5-6).
2. Drive the Feed Grabber to the service location.
Clean
1. Use a cloth or soft brush to remove all feed, dirt and cobwebs from:
• The cover (1) (see figure 65 on page 6-21) and the feed height sensor (2).
• Under or in the field of vision of the laser.
in n o vato rs in agriculture
To Next Page
Loading...
